Sip tubless spare

I recently got 2 off these sip tubeless  for my px200e. Upon reading some of this forum, people where asking can you put tubeless on the spare wheel bracket under your panel. The answer is yes. When i first tried  to put it on the studs where to short. Easy so fix. Add 2 m8 spacers, same as on the engine head for the cowling unto the 2 studs. Then put an M8 bolt from the back of the bracket at the bottom hole. Use 2 M8 bolts and one M8 nut to secure wheel. Job done. A 10 minute fix

[IMG]http://i55.tinypic.com/1824nk.jpg[/IMG]

[IMG]http://i56.tinypic.com/1267nmd.jpg[/IMG]

[IMG]http://i56.tinypic.com/anjvxt.jpg[/IMG]

 

 

 

 

 

rabmccomb,

thanks for the info, very helpful. do you happen to have the parts numbers for the parts i (we) would need to get?

thanks, heggie

rabmccomb,

thanks, that does help. i'll check it out and give it a try.

Hi i just bought two m8 (13mm) spacers, (extended nuts) which fit on the 2 studs from my local hardware, less than £2.00. Its the same as you would put on the cylinder head to attach your cowling. Then 1 long 13mm bolt to fit through the bottom hole, which is threaded. Job done. Hope that this helps.