I want to replace the standard rusty exhaust on my Totally Standard T5 Millenium for a Scorpion or SIP Performance. What do people think/recommend?
Is it worth replacing or not?
What one is better - scorpion or SIP?
Thanks in advance.
[?[] [:drink:] [:drink:] [:drink:] [:dance1:]
I have a scorpion on my PX200 and it sounds, looks and goes great. But in defence for SIP I have not seen one of theirs in action.[I)]
I just replaced a sito plus[similar to standard T5 exhaust] with a scorpion on my malossi kitted 200. The scorpion gives a really noticeable improvement in power at high revs, but loses out at low revs to the sito. So it all depends where you want the power.
As far as I know you cannot carry a spare wheel with the sip. You can with the scorpion as long as you fit a spacer. You will probably need to uprate you’re rear shock as well, especially if you carry a pillion as these pipes can ground on the left side.
Hope this helps
Mark.[:smokin:]I WAS IN THE SAME BOAT AS YOURSELF AND I FITTED A SIP POLISHED PIPE TO MY T5(172 KITTED).I ENQUIRED ABOUT THE SCORPION PIPE BUT WAS TOLD THAT IT WASN’T AVAILABLE AT THE TIME.I THEN PURCHASED A SIP PIPE.IN MY VIEW THE SIP PIPE LOOKS BETTER EVEN THOUGH THEY ARE BOTH MADE BY JIM LOMAS!!
EVEN WITH P@P FROM GERMANY THE SIP WAS CHEAPER!!!
AS TO FITTING A SPARE WHEEEL YOU CAN DO IT BUT YOU NEED TO SPACE THE BOTTOM THREADED BOLT OUT BY REMOVING IT AND FITTING A 100MM(4 INCH) BOLT WITH A CAPTIVE NUT-THIS ALLOWS YOU TO ADJUST THE GAP.
ANY PROBLEMS THEN E-MAIL ME[:drink:] [:drink:] [:drink:] [:drink:]
as the others have said a scorpo,and as richie has also said get it from the uk,maybe a bit more expensive,but youll get a better after sales isnt that rite richie,as most of u no what ive bin through!!!
[:dance3:] A scorpion for me, from a uk shop with a guarantee for the same money