Pinasco squish clearance?

What should be the squish clearance on my pinasco kit?
I have tried to measure using a peice of solder but it comes in at over 2mm at least.
I am using a stock crank and the supplied Pinasco head and a base gasket.
If I needed to lower the squish clearance should I remove the base gasket or get the head skimmed?

Hi there. I think most people recommend binning the pinasco head and getting another one. Worb 5 have the head you are after.

Anyone there?

thats fine but if i wish to continue using the stock head what should the squish be? I have been told that I should have really good compression and although it is better than the standard barrel (if i remember) i can kick the engine over bare foot.