Has anybody fitted a Pinasco 24T clutch drive plate to a P200E to replace the 23T original. Pinasco say the 24T will fit and mesh correctly with the 65T corona. I have put one of these on, and there now some gear whine noise on over-run/decelerate. Am a bit concerned about excessive wear as there is some noise. Anybody??
Hello Paulbishop,
I have the same noise as you describe in this post with the same part and bike. Have you had any major problems? The noise still occurs?
I have only seen your post on all web related with this part/noise, so I think this can not be a common issue.