Newbie; Jet and Pinasco 177 setup for VBB2T

I have my VBB2T 1963 1 year ago from a the old owner and now I want to rebuild my engine for 5 - 10 years usage (at least). Therefore I decide to apply:

Pinasco 177 Au cylinder kit

Crankshaft MAZZUCCHELLI

SI 20/20

 

1/ For my engine. Is this kit good enough for the daily usage?

A lot of discussions have been taken place to discuss about the SI 20/20 and 24/24. I know the 24/24 allow more fuel and air mix into the cylinder but:

 

2/ - DOES IT MEAN HIGHER FUEL CONSUMPTION?

If 24/24 allows faster cooling system but consumes more fuel, I rather mix more oil into the tank. I ride the scooter every day thus I also want to save fuel cost.

(the manual book says 2%. But according to my experience after 1 month using 2% oil, the engine makes crashing sound (i think because of too little oil and too much collision between the piston and the case). My Vespa engineer told me that this sound wont stop until i replace the new cylinder.

Hence to due with the cooling effect, next time I will use 4% of oil for daily cruise and maybe up to 6% for travel around 200 km

The reason I choose this cylinder is because it's a Au kit therefore the overheat problem will be reduced.

 

3/ Do you have other choice for the Crankshaft? Or only 1 choice MAZZUCCHELLI. Which one is the best?

 

4/ Do I need to buy the racing crankshaft to balance with the Pinasco 177 Au kit (I just need my VBB for daily usage, NOT RACING)

 

5/ My VBB2T is 2 ports (i think) so do I need to do any modification to my old engine? I dont want to do any modification at all, so in that case, do you have other recommend kit to my need.

 

6/ I want to use my old exhaust, is that ok with this new kit?

 

7/ I want to run it the most EFFICIENT, most SAVING COST, and most DURABLE

 

Please answer my question 1-7 in order so that I could have all the necessary information for my restoration.

Thank you very much