jetting advice on malossi 221

Hi i have just built a malossi 210 with a 60mm stroke crank which i believe makes it about 221cc i am using a mrp reedvalve and a mikuni tm34 carb and a dellorto fuel pump am running a doppler boost bottle on it and am running this through a rz right hand exhaust my question is can anyone advise me on the jetting and needle and float jet i should try running this set up on? i just need to get it close and then i can ride it to a dyno to get set up properly cheers greg.

 

no answer? better post an english message in the english section. then may you will get an answer...

good luck

 

m.