I have a SIP wide wheel kit with no instructions and need to know where the small spacer ring goes?? also does the rear disc kit fit with a PM EVO pipe on a T5? [:bounce:]
Hi Niall,
please use the Vespa Classic board for technique questions.
you must fit the small spacer ring on the left side of your engine case like shown in the drawing. therefore you must cut on 1cm of the case on the left side. → rear wheel is in the same line as front wheel
for the rear disc you must modify the bracket of the PM, because the silencer of it is very close to the tyre. not a big problem.
[I)]
Rgds, Alex
[:bounce:] Im having the same problem, i got one off of a mate and dont have a bloody clue how to fit the thing[:dance3:] It is getting to be a bit of a pain in the rear end trying to find out how to fit the thing.
Email me if you have any luck finding instructions will you, cheers!!
PS what bit of scotland you from, i`m from the south west.
[:drink:] [:drink:] [:drink:] [:bounce:] [:drink:] [:drink:] [:bounce:] [:smokin:]
are you sure about cutting off 10cm?? dont you mean 10mm.if you cut off 10cm you could have the engine under the other f***in side panel. px with a n//s engine? niiiiiiiiiice!!!
you cut 10cm of the right hand side of the case and put the spacer
on the left hand side it moves the center of the engine over
for the wider wheel
hope that helps
GrumC
[:itchy:]