Changing bearing in Sip Conversion Fork, aka PKXL2-fork


I'm able to move my fork sideways around this bearing;


Therefore I've bought this;


But how am I supposed to get the old bearing out of the fork???




as far as i know these need to be pressed out but if like me you dont have access to a press
but you have a bench vise put the forks in the vise with a large socket sitting in against the area you pictured it must be slightly smaller than the bushing other wise it’ll get stuck inside! this will push it out when tightened, then at the other side put a larger socket
 big enough to recieve the bushing your pushing out,tighten up the vise and keep going untill it pushes the whole lot out hope this helps!